Hey guys been checking the board as a guest and reading up. I just went to Home Depot today and got a starter set up going. I had some seeds from a bag I got in the spring. 1st time I have ever found seed in the stuff I buy. Anyway I read up and soked the seeds for about 15hrs and then put them in a wet paper towel like I had read. I then put them in a in a dark spot for a day and they both popped. Was happy the see they where still good. I hope I didn't go to fast but I put them in Jiffy-7 peat pellet. I put the white (root side) down and covered with just a bit of Miracle-Gro seed starter pottong mix.

My question is should I go ahead and start the light? Would that be to fast or pointless do to the no leaves? I only got one light so far and will go bad tomorrow to beef that up to say 6 lights. The one Light I got is a CFL 23watts, 1600 lumens, 5000K full color spectrum. Oh an the temp is at 81F and 48%RH. Is that to hot? Should I bring it down to say 78F or less?


Thanks guy I have enjoyed readding all your info on the site and look forward to learning more from you.
bigworm1922 Reviewed by bigworm1922 on . 1st frow question Hey guys been checking the board as a guest and reading up. I just went to Home Depot today and got a starter set up going. I had some seeds from a bag I got in the spring. 1st time I have ever found seed in the stuff I buy. Anyway I read up and soked the seeds for about 15hrs and then put them in a wet paper towel like I had read. I then put them in a in a dark spot for a day and they both popped. Was happy the see they where still good. I hope I didn't go to fast but I put them in Jiffy-7 Rating: 5