They all died . I just got done making new ones though. I used the Rapidrooters this time instead of the peat pellets. And I took 6 off each plant, 12 all together. Here's what I did step by step: 1.- I used a small pair of scissors (that I bought specifically for cloning at the Hobby Lobby store yesterday) to cut a tip off at about the 4th node. 2.- I then quickly dipped it into some Rootech cloning gel (I know it's not Dip n Grow). While it is soaking, I used my exacto knife to make a slit in the bottom of the RR so it will be able to stand up on it's own. 3.- Then, I sliced off the fan leaf that was just above the cut I made with the scissors and re-dunked it back into the Rootech gel. 4.- I gently put the clone into the RR. 5.- I used my scissors to cut the fan leaves down to an inch or so and placed them onto the tray. 6.- I sprayed the inside of the dome, not the clones, with tap water. They are then placed under 1 cfl bulb inside a small cab. Temps are between 70-75F and humidity inside the cab is about 50% inside the dome it is 70-75%. Can't seem to get humidity any higher even with the cup of water in there .