I wanna make a bong outta this

[jacquelyne]

http://everyonedoesit.com/online_hea...CategoryID=155

There. It's Poi-fect, no? And if it doesnt fit the bottle you can either shave the rubber or add duct tape as needed.

So that thing at the top is the cone ?
And the thinner hose hmmm
Is that where air comes out ?

jacquelyne Reviewed by jacquelyne on 03-11-2005. I wanna make a bong outta this Its a Black sambucca bottle. really thick black glass its 45cm or 17 1/2 inches long I need to know how i go about drilling through the glass.I think i need a special diamond tipped drill bit is that right?Also i think a normal drill wont go through that glass (even with a diamond tipped drill bit) as it would bounce around everywhere and probably chip it.Do i need a drill press?I have everyhing else i need i just need some advice to get the best neatest hole.I can always sand it if its a Rating: 5