MicroPC - Wiring Question

[12345-54321]

I'm making a new PC case, and want it to look as good from the outside as possible. I have used the power unit female end as the electrical source, its all wired it up and tested, this seems work, but I'm no electrician. I plan to cover the wiring with either a box or just a heat-shrink tube.

Any feedback about the pros and cons to this conversion?

Grow on. :smokin:

12345-54321 Reviewed by 12345-54321 on 09-08-2008. MicroPC - Wiring Question I'm making a new PC case, and want it to look as good from the outside as possible. I have used the power unit female end as the electrical source, its all wired it up and tested, this seems work, but I'm no electrician. I plan to cover the wiring with either a box or just a heat-shrink tube. Any feedback about the pros and cons to this conversion? Grow on. :smokin: Rating: 5

[henrydenken]

I'm making a new PC case, and want it to look as good from the outside as possible. I have used the power unit female end as the electrical source, its all wired it up and tested, this seems work, but I'm no electrician. I plan to cover the wiring with either a box or just a heat-shrink tube.

Any feedback about the pros and cons to this conversion?

Grow on. :smokin:

Heat shrink tubing is good for protecting the wire and the tube.But it would be best you to get some sample for the test.And it is alwasys shrink at 2:1 for normal. resist 125 degree.and satisfied UL224. Anyway,if you need help,please ask me give you a hand.

[12345-54321]

sounds good, any one elses' thoughts or comments on the actual wiring and whether it is safe / usable?

thx

:rastasmoke: