Well, two more holes for intake cut out. They weren't quite 2" (more like 1.5" or 1.75") so I think that poor exhaust was gasping for air. So it's got roughly 6-7 inches of intake for the 4" exhaust. It seems to be working better. That white plastic did not get sucked up again like before and so far the temp is a couple degrees lower. :thumbsup:

Took the doors off and put on a soft rubber sealer and used magnetic latches. This has helped the light leaks quite a lot. Still the tiniest bit but it's very unlikely that light will get IN, just the massive brightness of the HPS gets out in a couple minuscule slivers.

Here are a couple photos:

<- front view

<- back view of intakes.

Whew!