Improving the Volcano

[VapedG13]

I would argue that the first 10 seconds are not all air. According to the instructions of the volcano, it says wait 3 seconds. When I use mine I usually will press the air button and then put the bag on right after(within 1.5 seconds). If the bowl is big enough I will see vapor filling the bag instantly.

Try an experiment...fill your weed chamber about 3/4 full not 1/2 way or a 1/4full ...3/4 full:thumbsup: Place the screen assembly on top, now leave your bag off

preheat the volcano to 340* .... turn the blower/compressor on.... set the chamber itself on your volcano....time until you can see the vapor 6-10 secs depending on your strain

If you set your temp to 360 or above you will get noticable vape (visually seen) in about 4-6 sec.

I vape at lower temps I makes the vapor smoother....the higher the temp of the vape extract the harsher the vapor in the bag

Because of the lower temperature I'm vaping at it takes the herb longer to heat up so the vaping starts a few seconds later:thumbsup:

Basically what I meant was.... wait until you can see the vapor then attach the bag weather it 3 sec. or 10 sec.

VapedG13 Reviewed by VapedG13 on 11-23-2008. Improving the Volcano I just came across this blog post about making the Volcano more efficient: "During our experimentation we realized that using the bigger bag is not only easier it is also more efficient because you waste less vapor. Think about whenever you attach the Solid or Easy Valve on to the Volcano or take it them. There is always a little lost vapor; however, with the bigger bag you are taking the valve on and off the Volcano valve fewer total times per filling chamber, which maximizes your vapor by Rating: 5