i did that with a 5gal bucket, but when i learned it was called gumby because it was slighty different then bubble, but what i did was put in all my trim,all the ice and water... and agitated it with a drill with a big drill part *those things that drill for like a inch or bigger* its not a drill bit but it is like a stem of metal with a big square on the end for drilling big hole like 1 inch for about 10 minutes, left it sit for a couple hours, took a normal kitchet strainer and one that was smaller, strained it through the big one and use the second smaller one to compress it to get every possible resin water out, and then i took a vacuum hose after it had settled *left it for like 5 hours again* and sucked on the end till water came through, it keeps going until it gets air in there, so suck it down to like 5 inches above the resin, and then use a turkey baster to get it to about 1 inch above the settled resin. put it in mason jars until it settled again after pouring it in, and then turkey baster again till it was under an inch of water, and then let it dry for a while until it was like putty and then took it out and left it on a couple paper towels under a 60 watt incadescent *used incadescent cuz it gives off a general bit of heat* left it until it was like drying out clay,and i kept pressing it together into a ball and squeezing out excess water everyday after it gets to that point till its a solid. 750g of white rhino trim into 112g of some really nice hash