Heres what I got goin on with my stacked rubbermaid tubs.

I lined the inside with Foil Tape from walmart or your local home depot, lowes, ect... It completly stopped my light leak prob from the box itself. And if your gon spray paint it you should really use the Krylon Plastic Spraypaint. It wont chip at all, and after you spray a coat of that on, you can spray any other kind of paint on and not worry about it chipping. The Plastic Spraypaint is kinda pricey, arond $7 a can.

It looks like you have pretty good ventelation, but if you are growing stealth, you will have light leak issues with your intake/exhaust. once again you can get some ducting from the plumbing section of your depot store and rig it up to where the exhaust fan blowns into a 4" or 6" duct and out some flexible ducting. Then for your intake just get a couple 90 degree elbows and mount them in the spots you alread cut. I think you can get 3" elbows too.... Lemme let ya know that this stuff will only cost you arond $25 MAX.

My entire setup, lights, tubs, & supplies, only cost me around $70, But I am also using a 85cfm CPU Cooling Fan, mounted directly on top of the box. And 7 100w CFL's and my temps get around 78 during the hottes time of day and 66 at night.

Oh also... Expect your temps to rise a little if you use the foil tape. Thats kinda obvious though.... Foil duh! Retains Heat!

Anyway Here Are A Few Pics Of My Set Up. The One with the wires is to show you how I did the wiring for the lights. Just Match Colors.


http://i277.photobucket.com/albums/k.../IMAG000-2.jpg
http://i277.photobucket.com/albums/k...3/IMG_0023.jpg
http://i277.photobucket.com/albums/k...3/IMG_0026.jpg
http://i277.photobucket.com/albums/k...IMG_0010-2.jpg
http://i277.photobucket.com/albums/k...3/IMG_0011.jpg
http://i277.photobucket.com/albums/k...3/IMG_0015.jpg