My HID reflector has E40 socket with 3 pin power plug (same as PC power out).
I tried to wire the N pin to neutral, E pin left unwired and L pin wired to starter. Everything else is wired exactly the same as shown in the picture. I may not explain this very well so in this case for better understanding just replace the bulb in second picture with 3pin plug. However this didn't work.
I tried connecting without 3pin plug with just simple 2 wires directly to E40 socket and it worked.

So the problem is 3pin plug. I think something is wrong with these 3 pins. Do I need to use the Earth pin? I left it unwired.
daylight Reviewed by daylight on . HPS setup and 3pin cable wiring My HID reflector has E40 socket with 3 pin power plug (same as PC power out). I tried to wire the N pin to neutral, E pin left unwired and L pin wired to starter. Everything else is wired exactly the same as shown in the picture. I may not explain this very well so in this case for better understanding just replace the bulb in second picture with 3pin plug. However this didn't work. I tried connecting without 3pin plug with just simple 2 wires directly to E40 socket and it worked. So the Rating: 5