If you are running in hydroton, first soak it to set the pH to 6.0.
Then, take a big bucket and fill it with room temperature tap water. If you are feeling OCD, set it to 6.0 too lol.
Now fill your net pots with as much hydroton as you will need in your system.
Take the pot of hydroton in one hand and with the other, cradle the clone in your palm so the roots are protected.
Sink the net pot in the bucket, and the hydroton will loosen and float slightly. Now slide the clone beneath the surface of the water, protecting the roots still, and orient it according to the rim of the pot.
Still supporting the clone, by the stem now, slowly lift the net pot with the clone and hydroton in it back out of the tub of water. You probably lost some hydroton but as long as the clone is as deep in the pot as yu wanted it, you can just place the pebbles back in there around it.
Now you're done! You may have to hand water for a few days while the roots get going, depending on your system type.
stinkyattic Reviewed by stinkyattic on . transplanting clones I have searched here and IC for days. Mabee I'm not wording my search right.... When is "time" to transplant clones from EZ cloner to hydro setup Thanks in advance MsPB Rating: 5