Ok, day six and I've got some healthy looking seedlings. At least they are healthy as far as I can tell. I also have some new pics.





As you can see, I now have my Panda Film. I also bought two new bulbs because I realized the old ones were 4300k bulbs. So I went to wal-mart and bought some plant and aquarium wide spectrum bulbs. They are T12 bulbs rated at 20 watts. Unfortunately the LED panel I ordered was DOA. I will send that back and wait for my replacement. Until then this will have to do. If I decide it's not enough, I'll just go to wal-mart and buy a third lamp to put in.

My fans should arrive next Tuesday. Then I will affix them to the bottom and make my own carbon filter that will go underneath the cabinet so it can not be seen. I'm not sure yet what I will do for a passive intake, I will probably just let the cracks in the cabinet be the intakes until I figure something better out. The cracks mostly block light (except for a small spot that I will fix today) but should allow for enough air to come through.

Thanks for looking, and suggestions help would be greatly appreciated too.

Jay
JaySin Reviewed by JaySin on . Jay's first grow My cabinet is a 2.5'H x 2'W x 2'D I have two 17w 24" bulbs that I think are T8s (undercabinet light from wal-mart) So far this is all I have. Parts on the way are a 225 LED panel red/blue. panda film and 2 34cfm fans that will each get their own speed regulator. I plan to divide it into two halves eventually. One have for seedlings/vegging/and possibly clones and the other side for flowering/drying. Rating: 5