Results 1 to 4 of 4
Threaded View
-
03-11-2008, 09:04 PM #4
OPMember
Need to control PH
I added a picture of my set-up, the pots i was flushing are gallon pots I think. I ran about 2-3 gallons of tap water straight through it then the last quart of water was nuted at 6.3 PH. Right before I added the nuted water the run-off was 6.2 but after adding the nuted water it went down under 6 again. It didnt seem like the flush was raising it very much for the amount of water I poured through that tiny pot. Either way if you say its not dangerous, its not like my plants are dying I just was checking the PH chart and phosphorus calcium and magnesium are out of the optimum range for my PH level.
Originally Posted by carinia
Similar Threads
-
LST gone out of control.. HELP!!
By daihashi in forum Basic GrowingReplies: 9Last Post: 02-28-2008, 03:41 AM -
using CO2 to control ph
By Gen in forum HydroponicsReplies: 15Last Post: 04-14-2006, 03:01 AM -
CO2 CONTROL
By BOYZNUS in forum Indoor GrowingReplies: 7Last Post: 01-12-2006, 04:43 PM -
Out of control
By tupac2930 in forum Marijuana MethodsReplies: 3Last Post: 11-07-2005, 04:38 AM










Register To Reply
Staff Online