Quote Originally Posted by shibbysurfrider
yea i found this pre made dwc kit for like 30 bucks thats 15''x13''x7'' high. they are say they hold 4 gallons of water. i'll figure i'll have 2 of those systems with one plant each. ya 36'' is the outside height. inside its a hair above 34''. i found this high output T5 setup thats only 4'' high. so i'll still have about 2 ft of grow room. not much but it can be done with LST and SCROG. as for ventilation. i found these 120mm quiet computer fans that push out 70cfm. i'll shove 4 of those for exhaust and 2 for circulation. no odor control needed.

THANKS FOR THE INPUT!!!!!
have a wonderful day :hippy:
When I was starting out, I was looking at similar systems on ebay. They are NOT worth it. Order a small bag of hydroton and some net pots along with your nutes (3.5 inch are fine). Go to wally and find containers with lids that fit your space..(bring a tape measure.) containers range from 2 to 10 bucks, usually about 3 for the smaller ones. buy one 30-60 gallon dual outlet air pump for 10.87, 2 airstones that fit the containers you bought. (about 1-3 dollars each) Use one pump per bucket in flower, 2 stones per each. IF YOU MUST, you can run one stone per bucket, but more bubbles are better. Those setups that were 30$, were they from ebay? Was the shipping 20$ too? I usually found they were abut 50$ apiece shipped for suitable small ones. I find if you build them, you can buy xtra buckets and get your nutes stup and to temp (I need to heat mine because I fill from a hose in my basement I tapped into the pipe!!) That way just lift the lid, swap the lid and stones and GO! Also, the stones from walwart stay down pretty good, I dont glue mine so they can be cleaned better! By the way, the buckets need to be taped with black duct tape (2 layers at least), gorilla tape, ar painted black. Foil tape works well too, just make sure you get all the seams. Check out my setup to see what I built....http://boards.cannabis.com/closet-ca...ml#post1833858