Shown is a plant that I consider ready to clone.
1- Getting the hormone ready. Dip-N-Grow is fungicidal, and even mixed in this nasty ass test tube it roXors
2- The new growth on a plant that has been topped. This is where we take the cuts.
3- The pair of new shoots, including a node, slit right down the middle to make 2 clones... you only run into this situation in a young plant that has only recently gone alternating, and then, only when you are taking the whole top for clones.
4- They quickly go sit in the test tube of hormone
5- Meanwhile, while they are soaking up the juice, you take your rapidrooter and plunge the xacto blade deep into the bottom of it. The hole they come from the factory with is way too big for cannabis, and to avoid direct air contact with the cut part of the stem, and good contact with the medium, a simple slit works better. Then, you can use the RR free-standing with good air flow around the base, meaning faster rooting with less chance of rot.
stinkyattic Reviewed by stinkyattic on . Donkey Dick and VT local IBL Indoor/Outdoor 2008 Long time no log! Since the last one was something I've never done properly to completion before (a full hydro run using NFT), I figured that I should post this new learning experience. You can laugh all ya want. I'm NOT an outdoor grower but I was over at a good buddy's house a couple months back and he was like, "open your hand... Donkey Dick... Merry Christmas" and just dumped a big handful of these FAT beans in my open palm. I did some reading around and found the origin of the Rating: 5