most def. I would love to get a straightener with bigger ceramic plates, though.

Im trying to think of what I could use as a combustion chamber. I need something that can withstand high temperatures. Ive already decided that I want to vaporize by convection, not conduction, so I took some tin snips to a baking tray, perforated it, then folded it to create basically a wedge, crimped at one end, that I can put the weed into and clamp the straightener down onto.

I have used a number of different methods for smoke collection and extraction, and my most recent revision is one of those two or three gallon water jugs for the fridge with the little spout at the end. Fortunately, the spout on this particular one, is basically a rubber gasket that opens the seal via leverage when you press on a rubber knob in the center of the gasket. Anyhoo.. I turned it upside down so the spout was at the top, then cut a small rectangle out of the new bottom on the opposite side. I put the weed into the tray, set the straightener to the right temp, turned it on, and put it entirely inside the container. Then I sealed the hole up with a plastic bag and some electric tape. I let it heat up for a couple minutes, then just started taking breaths of the heavenly air through the spout.

Still VERY rough, but Im still working on ideas. Next, I want to deconstruct the straightener and find something to mount the plates, and the rest of the electronics without all that bulky plastic.