Resin scraping?

[DontPassOnGrass]

Ok
i have a pipe and a trumpet peice(that i use for the bowl of my sobe bong).
both r well resinated but i cant seem to find a very efficient way to get the resin out to roll into a res. ball.
should i jst scrape it out witha knife or what?

DontPassOnGrass Reviewed by DontPassOnGrass on 02-10-2005. Resin scraping? Ok i have a pipe and a trumpet peice(that i use for the bowl of my sobe bong). both r well resinated but i cant seem to find a very efficient way to get the resin out to roll into a res. ball. should i jst scrape it out witha knife or what? Rating: 5

[MiNdYoU]

back when i used the metal, i would take two knives, scrape w/ one, scrape onto anotha, very efficient. resin is nasty smoking, haven't been that desperate in a long time
either this or rubbing alchohol mixed w/ some salt, let it sit for a while and watch the goo pour out
my glass is once again clear

[Flaegrek]

Well for my metal pipe (Which screws apart) I heat the metal bowl and the inside of the pipe with a butane torch to loosen up the resin. I then take a prod tool, which is used for taking apart crab/Lobster meat, whatever it's called, it fits into the shaft of the pipe, I collect my resin that way, and then spread it onto a paper.

For my glass pipe, the bowl; I take my scraper and scrape the bowl, and then peel off the resin, collect a pile and roll it into a resin ball. Rinse and repeat until finished.

[Encatuse]

I just spread the resin onto a paper or on top of some bud.