ok, if this is the official cloning log as previously stated, without further delay,,,,,

here is the cloner I made up for WH.

1st an admission,,,or 2.
this took longer than I anticipated due to some circumstances beyond my immediate control.
aaaaaaaaaand,,,,
due to my notorious OCD and some mania thorwn in for good measure, the first version I was assembling was,,,well, ridiculously over-engineered.
Once I took a few breaths and realized I was creating the largest cloner in the history of cloning, I scaled back.
i had nearly all the parts here n there in my collection of 'stuff'.

Parts-
2x rubbermaid ruffneck 3gal tubs. (2 because i didnt really go for the foil tape thing, so, the walls are doubled to protect the roots from light.)
1/2 inch PVC tubing, because i had it on hand from a previous project.(cut to 2.5 inch)
1/2 PVC caps, for the ports not in use
2X 10 inch airstones
dual port pump
vinyl sink mat used to weight the airstones onto the bottom, cut out a few of the slots to weave the airstones thru, then cut in half and zip-tied to fit the tub properly.
lil clips and zip-ties to hold pump on outer tub.
and lastly, a fancy-schmancy on/off switch, just cause i had it and liked the idea of an on/off switch.

i cut the pipe holes tite, so there was no need for glue and also affords adjustability is desired.

thats it. hope you like it.
email me backchannel and we'll get this puppy out to ya:thumbsup:

oh crap, forgot to take a pic w-dome on, batteries died, ill get some and pic that too.