supplies:

1: a stainless steel water valve (5/8" O.D. x 3/8" Angle Ball Valve)

2: 3/8" Drive Spark Plug Socket - 5/8"

3: electrical tape

4: screen

5: weed

6: four way screw driver

Steps:

1: take the nut off of the water valve

2: get a 4 way screw driver and remove the knob that turns at the end (put screw back in is optional)

3: place socket inside the wide end of the water valve

4: take electrical tape and tape the socket securely and air tight to the water valve (i used half a roll secureing the socket)

5: place screen at the end where the nut was

6: place weed inside and smoke it up

(you can also use an adhesive to bind the socket and water valve together but i wouldnt recomend this because if u get it inside the valve u may end up smoking it *not a pleasant taste*)
neox Reviewed by neox on . handy mans bowl supplies: 1: a stainless steel water valve (5/8" O.D. x 3/8" Angle Ball Valve) 2: 3/8" Drive Spark Plug Socket - 5/8" 3: electrical tape 4: screen Rating: 5