Hi folks, I am a newbie and have a little problem.

Background...
Ebb and flow, watering about 15 minutes every two to three hours
GH nutrients, ppm is about 990
PH running around 6 pretty consistently
room temp avg around 83 maybe a bit higher sometimes
airflow, constant new outside air, 4" duct with small duct fan
fan on the plants
clay balls (forgot name) is the growing medium
light is HID 1kw, about two feet above
botanicare ebb and flow

OK, had two plants in wick system (I travel a bit...) and I got PH out of whack and burned them pretty good, were just going into flowering, enough to sex them, one was female, other male, trashed him, the female was damaged pretty bad, so got a cloning system and cloned some of her, it is aeroponic. Clones did very well, took eight and put in the ebb and flow, left about 10 in the cloner. They did very well for a few with a low ppm GH solution, about a week, like about 500, so I bumped it to about 1000, and they didnt react too well, first leaf tip burn and fringe, then curling, so dropped the ppm to about 250 and leached them good, then let that go a day or two and bumped to 500. They were still curling, but growing profusely, lots of lower veg, but leaves were/are still curling. Thought I was overwatering, which I was, had run them a few times for too long, over and hour, know better now, but now, no matter if I underwater or overwater, they are staying curled, and new leaf growth just curls up too, and weird things like leaf growth that is only one leaf, not three, and top leaves just come out and curl up and act weird. They are getting taller, but are still curled up pretty bad....

Not sure what to do with them....the clones in the cloner are fine, looking very good, in fact so big that will have to come out soon, roots systems much better and bigger than the ones I planted, and too big for the clear cover now, so they have to go somewhere and I am limited on space.

So, my question is, what to do? Trash the funky ones, start over with the better looking clones, and take the funky ones, trim them back, they would make great clones, they have tons of lower leaf growth I could trim back and clone them and have nice big clones with a 3/8" stem, and just plant the clones and start over....but if I am doing something wrong then I dont want to mess up the clones. This is a superskunk strain from Amsterdam, and I only had one seed do any good, and this is it, dont want to lose it....

They are about 6 inches high, maybe 7, and about two weeks out of the cloner, seems they should be bigger maybe...not sure, it is a low growing strain.

So, you geniuses, what do you think? Sorry no pics, my cam is trashed, and cell phone pics look like crap, too much light..

Arbogast
arbogast Reviewed by arbogast on . a little problem Hi folks, I am a newbie and have a little problem. Background... Ebb and flow, watering about 15 minutes every two to three hours GH nutrients, ppm is about 990 PH running around 6 pretty consistently room temp avg around 83 maybe a bit higher sometimes airflow, constant new outside air, 4" duct with small duct fan fan on the plants clay balls (forgot name) is the growing medium Rating: 5