How to make homemade glass bongs???

[JstUseDaBong]

Ive seen a few pictures of some bongs that are made of bottles such as Patron, Grey Goose, etc. How do you get a hole in it, can you use a drill?? Also what do you to seal it besides tape.

Please help me out they look really cool and i have googled it but with not to much success

JstUseDaBong Reviewed by JstUseDaBong on 10-19-2007. How to make homemade glass bongs??? Ive seen a few pictures of some bongs that are made of bottles such as Patron, Grey Goose, etc. How do you get a hole in it, can you use a drill?? Also what do you to seal it besides tape. Please help me out they look really cool and i have googled it but with not to much success Rating: 5

[420_24/7]

u can use a glass drill bit, or if your really really careful u can use a regular one, if your using a regular one, first mark where you want the hole, then take the drill bit and carefully hit it against the glass till it makes a small indentation, enough to keep the bit in place, then very carefully drill until you get a small hole, this is where most problems occur, if your using a small drill bit it wont be much of a problem, but it u want the hole bigger than the first small hole you need to, very carefully, turn the bit with your hands and chip very small peices off a a time. As for sealing it, you can get silicone based epoxy or any other glue that won't react to heat. Or a rubber stopper with a hole in it that u can glue in place.
hope this helps:thumbsup:

[THClord]

I used a glass drill bit, and I drilled underwater at a low rpm. Water absorbs some shock, +glass fragments won't fly at you.

It worked fine.

[JstUseDaBong]

Awesome thanks, any idea how much a glass drill bit cost and how can i make a slider with a bowl??

Thanks a bunch

[420_24/7]

glass bits arent that expensive, for a slider find a thin metal tube, and something to use as a bowl, like a socket or something, that fits into the metal tube and glue on a handle

[THClord]

Or you can go to a smoke shop and buy a stem+bowl.

[420_24/7]

Or you can go to a smoke shop and buy a stem+bowl.

that too, although im assuming that you want to make the whole thing, if not thats your best choice.

[nft]

Actually the reason water works so well is because water silences the frequency that broken glass makes (the frequency breaks more glass)

[SMOKEnCHOKE]

Drilling under water works well but once you start drilling don't add water. It will break, and you will feel like a dumbass when you think about what you did.

[WaZ]

Drilling underwater is mostly to absorb the friction heat from the drill bit (either submerge the bottle or run a flow of water over the drilling area) but has some other benefits as well like not putting glass shards in your lungs. While a regular bit might work, even one designed to cut glass can very easily crack a glass bottle, even when submerged. You have to make a small hole and slowly drill out from there to expand it. Last time I bought a bit for glass it cost $3-5.