HELP i have a white foam buildup on top of the water in my DWC Res..???

[cosmic702003]

The spigot line should not come off the actual RO housing itself, but be a branch off of the tank line. Remove the tee that branches it, and run a single line into the garbage can for good water.
If you cannot remove the spigot line, then just get a valve to fit on the end to close it off, or yes, put it in the garbage can too. My unit had the same feature, as it was sold at a dept store for drinking water, not marketed to our sector.
I repeate, it is not neccessary to hook up the spigot line to anything other than a collection can if you cannot remove it.

Peace

cosmic702003 Reviewed by cosmic702003 on 10-19-2007. HELP i have a white foam buildup on top of the water in my DWC Res..??? Ok i have a white foam buildup on top of my res water....there isnt too much of it but its on my roots now..and i dont know what it is....It happened a time before and went away in a few days...so idk what it is??? i am using GH 3 part nuts. and water from a local spring with a PPM of 220...someone have any suggestions or ideas?? Rating: 5

[Snowbdr1613]

ok thanks...yea mine is a Whirpool under sink model.....

[SCIENTIXT]

i will have to get gallons of RO water out of a tiny little spout..that is what im also worried about

If you get yourself a 3 1/2 gal filtered water jug, you can fill that in your kitchen sink, then go fill 5 gal jugs after your 3 1/2 jug gets full. This is if you can't get it to a bigger rez. Doing this I can fill 15 gal in six hours, thats with the tap on and off.

[Snowbdr1613]

ok thanks