I've only used my bubble-cloner twice, but got 100% results both times ... I took my cuttings bare, dipped in Schultz rooting powder, and put them into Rapid-Rooter plugs ... kept the water level about an inch below the plugs ... NO light first couple days, 24-hours on the airpump ... ONE drop Superthive per gallon of water, for rooting ... 85-degree heater ... NO nutes of any kind ... I don't know if any of this pertains to your setup, but hope it helps :smokin:
the image reaper Reviewed by the image reaper on . Problem cloningn with a aerocloner, need assistance. I recently got a aeroclonr, it's a 3.5 gallon bucket with four jet sprayers and 8 (eight) sights for clones.I placed three clones in it and after day two one fell over at the base where it is inserted into the inert.It seemed as if the inner part of the stem washed out from where the nodes that got trimmed off were through to the forty five degree cut on the stem, I checked the other two and they were the same.I went to removing the one that fell over and the part of the stem that was in the Rating: 5