Well, I snapped a few shots of my mini-mag lite pipe...

The first picture shows the pipe fully assembled and ready for transit. The end cap (battery compartment screw-on cap) got a hole drilled in it. It now functions quite well as a vaporizer with the cap in place.

The second pic shows the actual bowl part, with the end cap removed and visible on the disc in the back ground.

The third pic is just a pic of the filter I assembled in case the screen ever gets dislodged (its currently just pressed in place). I took the original lamp holder/switch assembly and over-bored the existing holes with a red-hot hair pin to increase flow. The lamp/reflector assembly's position can be adjusted to increase or decrease the chamber size after the filter. I did leave the filter in place as this pipe cools the hit very well, and the plastic reflector acts further as a tar trap.

Any questions, just ask!
Buck268 Reviewed by Buck268 on . Mini-Mag bowl pix Well, I snapped a few shots of my mini-mag lite pipe... The first picture shows the pipe fully assembled and ready for transit. The end cap (battery compartment screw-on cap) got a hole drilled in it. It now functions quite well as a vaporizer with the cap in place. The second pic shows the actual bowl part, with the end cap removed and visible on the disc in the back ground. The third pic is just a pic of the filter I assembled in case the screen ever gets dislodged (its currently Rating: 5