A little help with a waterfall bong

[make it legal]

Ok so i basically know how to make a waterfall bong, but last time i tried it, I wasn't sure how to get the bowl in the cap and keep it airtight. What should I use to make it airtight. Last time I tried there was like no suction bringing the flame into the bowl when they water was pouring out because the air was coming on the sid of the bowl.

make it legal Reviewed by make it legal on 08-18-2007. A little help with a waterfall bong Ok so i basically know how to make a waterfall bong, but last time i tried it, I wasn't sure how to get the bowl in the cap and keep it airtight. What should I use to make it airtight. Last time I tried there was like no suction bringing the flame into the bowl when they water was pouring out because the air was coming on the sid of the bowl. Rating: 5

[make it legal]

Ok so i basically know how to make a waterfall bong, but last time i tried it, I wasn't sure how to get the bowl in the cap and keep it airtight. What should I use to make it airtight. Last time I tried there was like no suction bringing the flame into the bowl when they water was pouring out because the air was coming on the sid of the bowl.

[Blitzed]

make a hole slightly smaller then the bowl peice, then just get it really hot, and stick it through. Also when I was younger id use lil tinny pieces of gum to go around the edge.. Idk if that is possibly bad for you.. but Im still alive

[Jadian21]

Is that a different term for a Gravity bong? Sounds like what you're describing I'm just not sure if the terminology is different where you're from or if you're talking about a whole different thing.

[make it legal]

No, but they use the same type of bowl-on-cap-of-bottle system.

Thanks, I'm gonna try using gum.

[Blitzed]

Similar concept except a waterfall has a hole at the bottem, where the water goes out pulling the smoke down with the suction.

[Jadian21]

Ahh I see, well yeah Blitzed covered it the way I'd do it. Small hole, heat it up, and slip the bowl piece in through forming a seal. Hot glue works too if absolutely needed.

[make it legal]

Yeah I would do that but I don't want it to be permanent. It's just the bowl part of my metal piece and I still want to use that too.

[Blitzed]

http://www.everyonedoesit.co.uk/img/..._waterfall.jpg

There is a nice lil diagram

[Jadian21]

Haha, I like how it says inhale, but what the hell kind of lighter is that?