slider bong!

[Travie_fresh88]

does any one know how to make one??? thanks for your help..ive been wanting to try one but dont have the cash so i was wondering how to make one at home...thanks again:rastasmoke:

Travie_fresh88 Reviewed by Travie_fresh88 on 08-06-2007. slider bong! does any one know how to make one??? thanks for your help..ive been wanting to try one but dont have the cash so i was wondering how to make one at home...thanks again:rastasmoke: Rating: 5

[stonerman07]

take a bic pen and a bottle. hold a lighter to the bottle, untill a hole starts to melt, when it is still smaller than the bic, quickly take the lighter away and force the sharp end of the bic through the hole. it will make a hole perfectly shaped for a bic as a stemm. then to get an air tight seal, wrap scotch tape once around the middle of the bic. after you gut the bic and put a bowl on it, slide it in the bottle untill the tape is halfway into the hole, then put water in up to under the whole. vwallah, you've got an airtight slider.

[Travie_fresh88]

thanks

[stonerman07]

+ Rep maybe??

[Travie_fresh88]

what do you usually use for a bowl? i just use a peice of tin can and roll it into a cone but little peices of weed usually come out the bottom..any better ideas?

[stonerman07]

i usually use a tiny socket, and put the round end on the pen and put tape between the pen and socket. but you can use the cone, and just put a tiny pebble in it. as long as its not a perfect circle, itll let air without ash through. i make homemade shit all the time.

[Travie_fresh88]

ok sweet...ill ask you from now on about homemade stuff...well since your here...how do you make a handpipe???..i used a plastic tube and burned a little hole and stuck a piece of tin in a cone shape and then burned a little carb on the side...its shitty though cause the tin keeps falling out...any recommendations???thanks dude

[O. G. ganja smoker]

noooo!!! dont do that shit its nasty if u need a pipe use an apple fuck tinfoil just get an apple remove the stem and get a skinny screwdriver push it down to about the middle(dont go too far). Then on the side of the apple make another hole conecting this hole to the other in middle of the apple if u have long hair take a bic pen remove all the shit from it so u just have a tube and stick that in the side hole not the top and put the bud at the top make sure it has air going through it when u suck on the side hole though and then there u go an apple pipe superior to tin

[stonerman07]

for a handpipe if you want a temp one, take a can, pull off the top opener thing, and dent the side and poke holes in it. ghetto as hell but gets the job done. or, carve out a piece of wood. but what you can do is burn the aluminum foil before using it for your pipe. this removes all of the harmful stuff.