Thanks in advance for reading my log & all your input!!! If you checked out my other thread (Growroom Setup) I was planing on a wood 10'X14' shed, but I ended up building a 10'x8' metal shed. Built a OSB roof with the metal roof on top of that. The intire inside of the shed is rigid foam board with a R-value of 7.5/inch. So a total of 18.5 R-value. On the left hand side of the room is the main grow area, and on the left there is a table for cloning/seedlings and random stuff. Lighting is provided by a 1000w HPS/MH switchable with a 18" cooltube. Venting is a "Can-Fan" 6" Inline Fan going through a carbon filter before exiting the shed. I have all the little stuff, 16" wall mount oscillating fan, ph meter, temp/humid gauge, timers, sprayer. I'm debating to put up panda film or mylar, I have both but the mylar seems like a pain in the butt to work with. Any input? I tried to take pics of the room but my camera SUCKS, so sorry for the low quality pics.



NorCal Grown Reviewed by NorCal Grown on . MY Shed-Log! Thanks in advance for reading my log & all your input!!! If you checked out my other thread (Growroom Setup) I was planing on a wood 10'X14' shed, but I ended up building a 10'x8' metal shed. Built a OSB roof with the metal roof on top of that. The intire inside of the shed is rigid foam board with a R-value of 7.5/inch. So a total of 18.5 R-value. On the left hand side of the room is the main grow area, and on the left there is a table for cloning/seedlings and random stuff. Lighting is Rating: 5