Results 1 to 9 of 9
Threaded View
-
07-09-2007, 11:24 PM #8
Senior Member
changing water dwc resevoir
depends on where ur set up is if u were in a shed or something. u could drill a hole in the wall and install a 3/4 inch pipe as close to ur dwc as poss. and then get a 3/4 inch threaded piece to thread in a 3/4 inch adptor that u hook ur black tubing to. cut the tubing to length to be long enough to make it to the bottem of ur res. then u hook the tube to the water pump. drop it into the res and plug it in and presto out side it goes. now on the out side what i did was dug down around 2 feet and put in about a half ft of pea rock or any rock or the black tubes with hole in it would do.
then where the pipe comes out of the wall u put an elbow going down and put the length u need on it where it's going down to the rock. and then elbow on that and put a piece about a ft or so so it won't drain right next to the building. then fill in the hole and no more buckets and no more hassle. or if u want like i did run a line under ground to your garden but u would still have to do the same from above with the rocks and stuff to drain proper.and u might want to install the clamp over the pipe to make it snug to the wall
Similar Threads
-
Resevoir Problem
By basementbotany in forum Plant ProblemsReplies: 9Last Post: 02-12-2008, 02:20 PM -
Question about changing water
By dougefresh in forum HydroponicsReplies: 6Last Post: 02-06-2008, 04:06 AM -
changing the g-bong or pale water
By delukssteelcityscum in forum Marijuana MethodsReplies: 4Last Post: 02-23-2007, 11:04 AM -
Resevoir Size for RO Water Storage?
By laidbackgreen in forum HydroponicsReplies: 1Last Post: 03-03-2006, 03:58 PM -
changing from tap water to ro
By friendowl in forum Indoor GrowingReplies: 4Last Post: 01-13-2006, 07:04 PM










Register To Reply
Staff Online