400w hps rubbermaid grow

[ghostofduke]

I am back after taking a little time off because my last grow was very disappointing (4 plants, 4 males), this time i am changing my methods to see if i can yield better results. This is pretty a practice run for my new setup, i am only growing two plants atm and if everything is successful this cab im using now will be the vegging cab while another one will be built for flowering.

And now for the equipment, new equipment priced in ()
1. 2x 32 gallon plastic bins ($8 each)
2. reflective tape ($9)
3. 1x 12in oscillating fan for intake
4. 2x stationary fans for exhaust
5. 2x 2 gallon pots
6. 8qt bag of MG Seed starting soil ($4)
7. 8qt bag of MG Perlite ($4)
8. 1x 400w hps light 50,000 lumens
9. remote temperature sensor ($10)
10. Soldering iron to make holes
11. 2x Top44 seeds

As you can see I have used my soldering iron to cut square holes, 1 at the bottom for intake, 2 at the top for exhaust, and 1 circle hold for the bulb. Later when this cab is converted to vegging i will install 120mm fans at least 70 cfm each. It could use more lightproofing but is fine for now. I just planted the seeds last night and im looking forward to a quick germination. Any questions/comments would be most appreciated.

ghostofduke Reviewed by ghostofduke on 06-02-2007. 400w hps rubbermaid grow I am back after taking a little time off because my last grow was very disappointing (4 plants, 4 males), this time i am changing my methods to see if i can yield better results. This is pretty a practice run for my new setup, i am only growing two plants atm and if everything is successful this cab im using now will be the vegging cab while another one will be built for flowering. And now for the equipment, new equipment priced in () 1. 2x 32 gallon plastic bins ($8 each) 2. reflective Rating: 5

[ghostofduke]

any suggestions on how to make this more light proof?

[Mr.Blue]

paint it black?.....

[Big len]

I have same setup with about 600 watt cfls putting out 39,000 lumens, I only coverd places I missed when taping in side on the outside do this in the dark with light on in cab. I never messed with where the 2 containers meet and have had no problems.
Big Len

[iblodro4220]

it dosent get to hot? ive got a closet grow 4X2X10 with 250watt hps with good vent. and heat still gets to 83 at times....