in a very extreme situation I could pull the plants off the table there are 36 in 4inch pots filled with hydroton but I have panda film covering all the pots and I also dont really have anywhere I could put the plants if I took them out ive got a good 12 inches of roots coming out of the bottom at this point i wouldnt want to just set them down..Im thinkin a floor jack and maybe some jack stands will do the trick I can jack it up and put the stands in to hold it while I cut the sawhorses down to size and then just lower the table onto the smaller sawhorses...this appears to be the best way Ive heard so far any one else have any last minute suggestions?
mike024 Reviewed by mike024 on . 4x4 ebb and flow table question Hey all been a while since Ive been around but ive come accross yet another problem I cant seem to find a feasible answer for...Ive got a 4x4 table on saw horses that I put together and the table is too high just as youd expect My girls are in week 3 of flower and i vegged too long so I gotta drop the table. I cant seem to figure out the safest way to replace/modify the current table with minimal risk to my girls...Its a very simple table 2 sawhorses with 4 ft 2x4s connecting them and two Rating: 5