Results 1 to 10 of 171
Threaded View
-
06-09-2007, 07:51 AM #11
OPSenior Member
How to build and maintain your own custom bubbler DWC grow
06-08-07 Day #18 of Veg.
Cab Temp: 79F
RH: 49%
Nutrient Temp: 70.7F
PPM: 1061
pH: 5.6
Thanks earthy, they definitely are getting bigger and doing better as the days go on. We are especially pleased with the runt in the back as it was taking the slowest to the nutrients. It is still the only one that doesn't have roots down in the nutrients yet but it will any day now. As you can see the roots are looking great and dropping down into the nutrients. We now have it on a cycle where the drippers turn off at night to let the roots grow a little and to allow some air circulation in the roots and clay pebbles. We have been slowly diminishing the nutrients down to the 1100 & 1200 range by just adding water daily and diluting. To answer your question we will probably flower at about 1 ft tall. Within the next week we will top the plants and I will show that in detail. The tallest is about 7 inches tall so we have a little bit to go yet before topping. Topping is recommended after the 2nd or 3rd node but we will wait until the third gets fully developed before topping since they are just barely at 3 nodes right now.
Advertisements
Similar Threads
-
Omnibuddy: Custom LED Grow Log 2 - Here we go again!
By omnibuddy in forum Grow LogReplies: 39Last Post: 09-18-2011, 06:39 AM -
Omnibuddy Custom LED Grow
By omnibuddy in forum Grow LogReplies: 109Last Post: 06-13-2011, 11:44 AM -
Recirculating DWC - Custom LED Grow
By ledtime in forum Grow LogReplies: 14Last Post: 07-14-2009, 01:33 AM -
how does this new hydro bubbler I just build look?
By hydrocannabis in forum HydroponicsReplies: 18Last Post: 06-08-2007, 02:04 AM










Register To Reply
Staff Online