Hey oldSanClem,

Thanks for all the help!

I think I have a better understanding of the setup now.

So, this is the card I need to buy to hard-wire the stuff.


Question, if I'm using this card, the PCI-PDISO16... ok, I'm going to use that for inputs.
Fine.
But, the sensors... do I use the ones I've got now?
I've got a Hanna in-line monitor... ppm, pH, temp, etc.
It has two probes.
Can I just splice the probes' cables into the PCI-PDISO16?
Or do I have to buy one probe for each input into the PCI-PDISO16?

Thanks for answering the n00b questions!
Much, much appreciated!

Best Regards,

-turtle420
.
turtle420 Reviewed by turtle420 on . Automation Does anybody still use old fashion timers, with old computer around. Why would anybody us a a timer , when you can set up to 8 channels with a printer port relay $36 to $120 and a controler program likd relayrunner.With over 15 plus years of using a computer with one failure,(dam compute battery went bad the same day as the power went out) It has a restart thats part of the program. Do a search for relayrunner, it has a free test , so you can start it up , under emulation mode , make all your Rating: 5