My New timer from Lowes?

[hayze21]

Hey all I know this is a stupid question but I have a timer that I cant figure out for the death of me damn n00be that i am but need help setting this Mother......it has 2 red pins and 2 green pins and a switch on top with on and off...my question to all is how many pins do i need to set up for the timer should i just just use 1 red and 1 green and take the others out or are all 4 needed to work? Sorry guys for the retarded question......:thumbsup:

hayze21 Reviewed by hayze21 on 04-19-2007. My New timer from Lowes? Hey all I know this is a stupid question but I have a timer that I cant figure out for the death of me damn n00be that i am but need help setting this Mother......it has 2 red pins and 2 green pins and a switch on top with on and off...my question to all is how many pins do i need to set up for the timer should i just just use 1 red and 1 green and take the others out or are all 4 needed to work? Sorry guys for the retarded question......:thumbsup: Rating: 5

[Tokudai]

Hey all I know this is a stupid question but I have a timer that I cant figure out for the death of me damn n00be that i am but need help setting this Mother......it has 2 red pins and 2 green pins and a switch on top with on and off...my question to all is how many pins do i need to set up for the timer should i just just use 1 red and 1 green and take the others out or are all 4 needed to work? Sorry guys for the retarded question......:thumbsup:

The green pins turn it on and the red turn it off. It should have a little clock or something to set the relative time with. Once its set, then put the pins in when you want it to turn on and off. ie green one on 12 and red one on 12 for 12/12 bloom cycle, or put the red pin 6 hours later for 18/6

[hayze21]

Yes it does a have a current time set on the front.....for 12/12 I was going to set it for on at 6am and off at 6pm then start back on at 6am and repeat......So i just need 2 pins then right 1 green and 1 red?

[Big len]

Hi set large wheel to current time am pm it should be on dial put pins in where you want light to come on or shut off if you are going 12 /12 you will only need 2 pins if you are not shure, plug into any lamp and set for a short period to test, did this timer not come with directions.
Good Luck
Big Len:rasta:

[PharmaCan]

Yes it does a have a current time set on the front.....for 12/12 I was going to set it for on at 6am and off at 6pm then start back on at 6am and repeat......So i just need 2 pins then right 1 green and 1 red?

You are correct - you need only one red pin and one green pin.

[hayze21]

thanx a lot guys for the input much appeciated