The Bong Shall Rip Again!!!!!!!

[mattks1]

i guess my bong just had to break since everyone else is talking about theirs breaking. me and my gf were sitting in her room and we heard the bong lose balance and fall over. it must have hit on the end because it snapped it right in half with a clean cut. i had read about ppl using fishtank epoxy and crap like that but i needed to smoke. so, i had some JB WELD layin around and mixed some up real quick. i would suggest that stuff for anyone tryin to mend their smoking lamp. if it will hold my exhaust manifold together on my jeep, then it will keep this together. sealed like a charm and strong as an ox. just thought id share the JBWELD tip with you guys. its about $4 and comes with a tube of steel epoxy and hardener. mix equal amts of each and apply it to the break. let it cure for about 4 hrs and voi la, all fixed.

mattks1 Reviewed by mattks1 on 04-14-2007. The Bong Shall Rip Again!!!!!!! i guess my bong just had to break since everyone else is talking about theirs breaking. me and my gf were sitting in her room and we heard the bong lose balance and fall over. it must have hit on the end because it snapped it right in half with a clean cut. i had read about ppl using fishtank epoxy and crap like that but i needed to smoke. so, i had some JB WELD layin around and mixed some up real quick. i would suggest that stuff for anyone tryin to mend their smoking lamp. if it will Rating: 5

[dankkeeper]

JBWELD I love that stuff. Superglue on steroids.

[go toke up]

good advice. Thanks :smokin: