Cracked Bong

[Gunner420]

if u dont feel like getting supplies, just use gum

i use gum to seal homemade pieces all the time

[slipknotpsycho]

just go to your local auto store or walmart and get windshield sealant or any type of clear sealant. dab it on there and wipe it clean. leave it a couple hours and your good to go.

yup....

if you ain't done nothing to it yet, go to walmart in the auto section and get 'windshield repair kit'... the one i bought was about 8 bucks... can't glue broken peices back together... but for cracks.. that shit works wonders.. if you do it right, and can still see the crack, i'll honestly be suprised.... i tried to use it to put a bong back together (it was in peices) and even then, it DAMN NEAR made the cracks invisible.... (dunno what's in the shit, but it just works wonders lol)

do that tho.... it'll take care of the crack both visually and strength wise (windshields are some fo the most scrutinized glass aroudn when it comes to structure, so if it can be used for that, it should be even better for a bong..

[fatweedsack]

yeah ive got some superglue i was thinkin of using. used it on my slide which had the stem busted off and it broke after a few hits.

[Ramen_General]

i like caulk

[slipknotpsycho]

ok lemme rephrase, if you give a damn at all about appearance, get a windsheild repair kit.... otherwise, duct tape works, so does super glue..

[ipodguy]

ive used hot glue

[PabloEscobar1904]

my bing just got a crack on the bottom bubble about 5 or 6 inches long, i read up on the windshield repair and it sounded like it was just for chips in the glass not cracks. So will the adhesive or glue fill a whole crack as big as mine?

[Yah dumb nug!]

I dont know about duct tape man.....cuz last night my friend bumped the side of my glass bong on a table and a big chunk of glass broke off and we tried to cover the hole with duct tape and it leaked like crazy....

O well....P.O.S bong anyway

[v0Lume]

go to you local hardware store and pick up some two part epoxy, its clear and it bonds basically anything PLUS you could even sand it down so it looks like the bong was never broken

[eevus]

do NOT use super glue,it has trace amounts of cyanide,but a windshield repair kit or hot glue would work