Hi everyone, let me preface this by saying ive googled and searched the threads, but still have some concerns, about my friends cheapo aero tub.

The basics: 4 10inch bubble wands, water heater preset to 78 degrees, in PH balanced distilled water in a rubermaid tub. my friend has the bubbles on 24/7 and the clones are under a 6500k CFL .

The good news:
The cuttings are looking pretty healthy, in fact better than when they were on the plant. they are greener and standing up straight, going toward the light.

however i am concerned because its been a week (today is day 7), and i see little to no signs of rooting. according to all ive read the conditions are right for rooting, and i should have seen some signs by day 5. the tub is completely opaque and little light can get in the water. (only through holes made for the tubing and the heater, which he covered the gaps as much as possible with black plastic.

The cuttings should be proper enough, they are about 4 inches long each with at least a node submerged in the bubbles. i re cut them underwater at a 45 degree angle and everything as to prevent that air bubble thing from happening in the stem.

Sorry for my ignorance but i would really appreciate any feedback from the experienced peeps out there. Im hoping that by day 10 ill see some positive signs. Please share your thoughts on this. The model i based mine off of was that one from overgrow.com.
aaprime Reviewed by aaprime on . ==HELP NEEDED CHEAPO AERO CLONER CONCERNS== Hi everyone, let me preface this by saying ive googled and searched the threads, but still have some concerns, about my friends cheapo aero tub. The basics: 4 10inch bubble wands, water heater preset to 78 degrees, in PH balanced distilled water in a rubermaid tub. my friend has the bubbles on 24/7 and the clones are under a 6500k CFL . The good news: The cuttings are looking pretty healthy, in fact better than when they were on the plant. they are greener and standing up straight, Rating: 5