These are simple instructions for making a very stealthy zippo pipe.

1. Get a zippo. Must be generic shaped rectangle.
2. Open it up, and rip out all of the cottony stuff inside, make sure you get all of it, and then rip out the wick.
3. Clean inside, just to be sure. Take a q-tip and w/e and just make it sterile.
4. Good to go!. Now, you take a small bud, up to .4, and squish it a little into some tin foil. Put it inside the zippo, where the cottony stuff used to be. If
you'd like it to be even more transportable, take a pack of matches and rip off half of the light-pad. Take a few matches, rip them in half, and they'll all fit neatly and comfortably inside the zippo.
5. Put it back together, close it, and voila! A completely stealth portable smoking device with stash and flame.
6. Light that bitch up! keep the bud in small chunks, pea sized, and before you put them in the top, flick the little peice of metal that holds the case closed inwards. It will block the bud from escaping.
You smoke it like this!
Inferius Reviewed by Inferius on . Zippo Pipe These are simple instructions for making a very stealthy zippo pipe. 1. Get a zippo. Must be generic shaped rectangle. 2. Open it up, and rip out all of the cottony stuff inside, make sure you get all of it, and then rip out the wick. 3. Clean inside, just to be sure. Take a q-tip and w/e and just make it sterile. 4. Good to go!. Now, you take a small bud, up to .4, and squish it a little into some tin foil. Put it inside the zippo, where the cottony stuff used to be. If Rating: 5