hellppp meeee....plz

[jaGerbom]

i just stuck a pen in on the underside of a socket and put that through the cap of a sobe cap....there are lil bits of air slipping out and i was wondering what u guys do to cover up small holes...normaly i use gum but i want something else this time. what do u guys use to make your homemade socket bowls airtight?

jaGerbom Reviewed by jaGerbom on 03-22-2007. hellppp meeee....plz i just stuck a pen in on the underside of a socket and put that through the cap of a sobe cap....there are lil bits of air slipping out and i was wondering what u guys do to cover up small holes...normaly i use gum but i want something else this time. what do u guys use to make your homemade socket bowls airtight? Rating: 5

[Kid Dynamite]

I use a glue gun. If your gonna make alot of bongs at home, then its apretty invaluable tool...

[O' Cannabis]

Sticky tack

[Jderringer]

epoxy

[Machello]

peanut butter for fun cleanup

[GratefulDead4ever]

Best bet is to go with the glue if you dont have a glue gun just get some glue sticks and heat one up with a lighter til it begins to melt and then rub it around the area of the bottle that needs to be sealed up thats what me and my friends usually do when we make homemade pieces

[GosTo]

peanut butter? how well does that work?

[ju99al0b0mb3r]

peanut butter? how well does that work?

its yummy

lawl

[ballllin]

i got grey duct tape. will seal anything.

[one.stoned.wookie]

now for ghetto bongs i just get a damn normal bowl head there like 1.75 from a headshop and get some heat proof tubing or something and just make it a stick in type bowl or screw it into some pen cap.....but to seal something like a socket use some 2 part epoxy with a high heat rating also dont have plastic too close to bottom of bowl only have the tube like 1/4 of the way in the epoxy will hold it fine and be sure to sand both parts where epoxy is gonna go and clean it with rubbing alcohol before u start make for a better bond *almost typed bong*