heard of loads of ways but trying to find the best.
Printable View
heard of loads of ways but trying to find the best.
the way my dealer always used
wrap the block up in some kind of plastic bad (tightly)
drop it in a jug/sink of boiling water for a few minutes
then take it out, unwrap it and you can cut it easily by pressing down on it with a sharp knife.
works even for hard ass soapbar.
Dude..
Not boiling water for a few mins, no..
Warm up a knife, not to much though, and then press it through.. If there comes smoke from the hash, the knife is to warm.
that way works too... but it depends if he is cutting up a 1/4 into 2 eigths or if hes hacking up a 9 bar. If hes doing a big thick chunk then its gonna take more than a warm knife.Quote:
Originally Posted by PaRaNoIa
that^^ doesnt sound too good:confused:Quote:
Originally Posted by Kid Dynamite
you could try putting it in the oven if your gonna be cutting it all up....but if you just want to cut ( for example a oz off ) i would suggest putting it on top of a toaster, just put the part you wanna cut..over the spaces where you put the bread in....then wait:rasta:
I would never put it into anything hot for a longer period..
We don't get them in Oz's.. We get them in 100 gramm plates.. Or 200.. 300.. etc.
And they are easy to cut up.. Always with a knife.. Sometimes, you can take a giant cooking knife and put it in a pot of boiling water, so that it gets hot, mark up where you want to cut, and then put it in the pot again then you cut up.:)
i was taught when u have a decent brick sized lump you use a cheese wire
Also good..Quote:
Originally Posted by chisme
But I always use a knife when I cut up... Because, I never own the hash bars, so I get a little, and keep what comes of onto the knife..:)
Last time i had a 5 oz brick i used one of them small hand held axes... you know what i mean... erm... you know the ones that are like 30 cm long... the small ones. One big hit and you can make a perfect cut.
Ahh..
You can't get a perfect cut, no.. Not the way you want it.. An example, you can't get that exact 1/8 from that.. You'd have to have a hammer to bang on the axe with..
Method: Put the edge of the axe where you want to perform the cut, and the WHAM with a hammer on the axe..:)
omg!!!! retards!!! listen all you do is wrap it in cling film and bang it in the microwave for 10 seconds or whatever time you want and then the bluntest knife in the world will slide through it like butter i mean come on put it in boiling water???? what have you been smoking apart from weed of course"!
Putting it in the microwave is just as dumb as boiling water. The microwave probably vapes away half of the THC anyways.Quote:
Originally Posted by £hustler£
Just use a fuckin knife people. Not that hard to comprehend. Use a butcher knife if you have too. If it can cut through meat, then it can cut through hash.
the thc doesnt get vaped away mainly because there is no thc in soap bar but more to do with the fact the cling protects the bar and prevents any escapeing goodness
Of corse there is THC is soap... just not alot. Which is why you dont wanna waste any of it at all.
and anyway, why would someone buy enough soap to be able to cut it, i assumed he was talking about good hash
Such a brainiac..:rolleyes:Quote:
Originally Posted by £hustler£
The microwave, I agree with nochowder..
And no THC in soapbar? There is THC in soapbar.. Don't be such an idiot.. It's just the same as saying males don't have any THC, wich they do.
Question is what you been smoking????Quote:
Originally Posted by £hustler£
Im mean microwave.....microwaves are for chicken hot pot...warming a cup of tea up etc etc,not hash!
Why did u question the boiling water trick when your happy to use a microwave.
Do Not use heat for hash it kills the THC content(its what gets u stoooooned)
Ive seen posts about using axes and knives....das more like it.
I use a big knife,lay it on the hash and twat it with a hammer.
If i saw more dealer put a lump of hash in the microwave...i`d probably stuff her in with it!!!!
:dance:
Quote:
Originally Posted by PaRaNoIa
Cling film stops the thc escaping....lol....what like a pair of hand cuffs.
Um no!
Its not that the thc evaporates its the tiny thc balls that explode decreasing the potency while microwaving
Most of the times i can just use the warmth of my hands to chop it. I believe it has something to do with the quality of the hash.
He is actually right what he is saying about he micowave....if....and only if you are the shittest dealer in the world......
...on many occasions I have seen people wrapping nasty Solid in cling film and banging it into the microwave.
......Best way to cut is to heat a good kitchen knife up on the gas cooker and place it into the middle of the bar........
......WARNING........PLACE A TEA TOWEL OVER THE TOP OF THE KNIFE WHEN CUTTING!!!!
......I've had a few nasty burns when I forgot to have one and pressed down on a scalding hot knife, leaing a lovely burn line across my palm!
at what point did he say it was soap bar? you fucking moron, you chat so much bullshit anyway.....wrappng in clingfilm keeps the "goodness" from escaping?.,......anyone who knew anything about hash would know that the goodness would come out in vapour...the vapour apon contact with the clingfilm will deposit....RESINS...yes that right....goodness....now unless your gonna sit there and bong the cling film i would shut the fuck upQuote:
Originally Posted by £hustler£
pwned.
If its soap bar just throw it in the bin, cause it should not exsist..lol. If the hash is soft you should just be able to cut right through it with out heating it up.. .. Infact you really dont wanna be heating it up anyway... Peace:stoned: