Brakes on my landcruiser

I am going to go put some front brake pads on My landcruiser. It is so easy. I am going to post, and then time my self, by posting again.


it might take me a while cause im dealing with almost 3 feet tall tires

all you need are Lug wrench, pair of pliers and 2 flat head screw drivers, brake cleaner, and a scotch brite pad.


you pull the wheel

pull the set pin out of the pads

use screwdrivers to push pistons back in the caliper

remove old pad, (clean and take glaze off of rotor)and put new pads in (they have this little window to pull the brake pads through....super cool)

replace set pins

clean brake fluid off drive way

lets see how this goes....good saturday fun, see ya in a few

:thumbsup:

one side done

damn one side already? you're fast nig. Usually takes me a little longer on my jeep, but im never in a rush.

Done


it is the best....you could do those brakes in the middle of the forest in about an hour

going to clean up my mess in the drive way thats all

dam that was fast Landcruisers are really simple Toyota did a good job on them:thumbsup: .

what year

all clean and test drove and all

Quote:

---

Originally Posted by cygnustaxt

damn one side already? you're fast nig. Usually takes me a little longer on my jeep, but im never in a rush.

---

i kinda cheated.... i was a toyota machanic for a while..... iam used to working FLAT RATE. That job only pays like 1.2 hrs and that means using an accuturn brake lathe. I am fast and good.

Toyota out did them selves on that rig......

here it is

click on it for better pic

Nice ride but you would have been better off buying a surf!

Nice ride...I've smoked in that pulloff,nice altitude buzz!