Is there any possible way to tighten joints after they have been rolled?
Printable View
Is there any possible way to tighten joints after they have been rolled?
tear em open and re-roll, of just pack more in the end if you can. Give it a little twist can help too.
Roll it inbetween computer paper
After you first roll the j if its to lose then you could twist it with your lips.(also meakes it burn longer.)
erm.. anymore??
Twist one end tight, hold the other end and shake it back and forth gently. Then just tare off the excess paper. Works for me at least.
Have a good one!:thumbsup:
was just about to say thatQuote:
Originally Posted by Psycho4Bud
there's an alternative to this...flatten one side COMPLETELY so all you see is paper, then hitting the 'flat' end over and over relatively hard... it'll pack it down better/evenly... but if you hit the loose end, it'll do just the opposite...
k, lick it a little bit all the way around, not rediculously wet, just to make it moist, and make sure every part of the joint is moist too, then put it in a dollar bill and roll it around...it works 70% of the time, everytime
if possible, i do this all the time, just either remove the roach (if you have one) or untist one end. then take a match and pack the weed further down into the already rolled tube. of course this will make it shorter, but i like it as it burns longer and more slowly, doesnt break or bend as easily, and overall feels more sturdy in your hand.
dollar bill trick- used to do this back in the day get your joint and a dollar bill (or any bill it dont matter) but it in the middle as the bill is vertical then bring the two ends of the bill up and grab them then take both hands and pull it up and down and it tightens....if i explaned it good enuff then you should get the idea.
turns out my joints were too tight and i coudent draw any smoke threw.. i opened it and rolled a looser one still didnt burn :confused: it was either the wind or something else?.. the bud wasent wet. So most of it went into the air due to keep relighting :( .. i need to learn to roll better.
lol, just keep practising, see if you have a friend who can roll around so he can tell you what your doing wrong. Its hard for someone to tell you what your doing wrong when they can't see.Quote:
Originally Posted by Chainsaw1234
:rasta: get the joint real wet,then roll it between a dollar bill.
2.50 roller
pack it down with a pencil
I was just about to say that. I find that it's easier to use the end of a pen. Do it slowly though, if you push to hard, the joint will bend, so just be sure to do it carefully.Quote:
Originally Posted by ozkid