Printable View
I have trouble when I first put my screens into my pieces with getting them to conform to the bowl and stay like that, I just push them down hard and then it just sits in there and if I turn it upside down or shake it, it moves. I need to figure out how to get it to stick in the bowl like it's part of the piece, anyone got any ideas?
Resin man, just get it in there good, then start smoking.. That sticky black glue will hold it in there!
yeah all u gotta do is keep putting it in there when u smoke eventually it just wont come out enmore
id say about after 4 bowls it should stick good
Let the bowl resin up by smoking bowls, after that the resin should hold the screen in. To make sure its a good fit you should try and get the screen to be curved just like your bowl so it fits well.
I already tried all of that. The problem is that the screen is so loose that between bowls it moves around and if that keeps happening it won't ever get stuck in there.
then smoke like 5 at once.
seems like u need a smaller screen clip it down to size
Just keep on smoking, there are ways of forcing the screen in, but your could break your piece when doing them. Play it safe and keep smoking bowls, try it without the screen, I think that the resin might stay on better if it is in direct contact with the glass.
if its a glass piece then fuck screens just use a bit of larger bud to cover up the hole then just pack it up!:stoned:
yeah bro resin it only takes a couple bowls its what breakin her in is all about