welcome to headshake's hempy adventure!
what's good everyone? i decided to start a new log and dedicate this to the hempys that i've recently started thanks to being inspired by killa! i will still run the official test log for the wrecked homicide.
on with the show.....
for the buckets themselves i've used old one gallon milk jugs. i put a 1 1/2" hole ~1 3/4" from the bottom of the jug. i then cut out around the handle to make a bigger hole in the top while retaining the handle for use. after that i wrapped them in black electrical tape. the work pretty damn well.
i've been giving some thought to the holes. i don't think they need to be holes at all. they could be a decent sized gap cut out or burnt out with a soldering iron or the instrument of your choosing. if i'm not mistaken the hole is just to create a mini reservior. the placement shouldn't matter all that much either. the higher the hole the bigger the res. with that being said, please keep in mind that these are the ramblings of a mad man and nothing more and should NOT be taken as any type of gospel!!!
also, i think a piece of some sort of screen super/hot glued on the inside of the container would be a help. when the medium gets dry it does fall out. it also falls out when the mini res gets full. it's not terrible, but more of an annoyance. again, this is an OPINION!
as for the medium, i'm working with a 50/50 mix of perlite/vermiculite. i'm using this mix as a starting point as i have read many different opinions on the subject. again, this is not a recommendation. i know killa likes a 4:1 ratio of perl/verm. i've read others like a 60/40 perl/verm split. i just took some cuttings (more on this later) and they will go in killas preferred ratio for comparison. perhaps one of each strain's cutting in one of each perl/verm blend?
now for the setup:
i'm running a 4' x 4' tent thanks to irydyum. thanks again bro! the light is a 400W MH. the bulb is just a plain jane found at lowes. i have a homemade reflector. it's a piece of the old box aka frank for those of you who've been tuning in for a while. i have no exhaust at the moment, but it's not a big deal since the temps recently have been in the 50-60 degree range with sporadic days up to the low 70's. the tent runs anywhere from 11-16 degrees hotter than ambient. i think the hottest it's reached was 86 and usually if it hits the 80's at all it's around 82. it normally stays between 78-89, but sometimes will run as low as 71 with the cool weather. i also have a fan for circulation.
i'm using the tent for flowering, but i move all the veg plants in there during the day because for at least now there is room. when the bloom room goes dark i move them under 16x 23W CFLs most of which are 6500K with ~4x 2700K for a mix (and to fill sockets!).
i'll be using fox farm nutes, reason being is that i still have 1/2 bottle of tiger bloom, an almost full bottle of grow big hydro (not to mention a 2/3 full bottle of grow big soil) and all the soluble powders are almost full still. i need to pick up another quart of big bloom and i think that will allow me to use the majority of the other liquids and a good bit of the solubles.
and now the starts of the show:
***these have been vegged for 33 days***
-1x death by purple (thanks killa!) this is the biggest plant of the bunch. it took FIMing extremely well. it is thick and hearty.
-1x wrecked homicide. (thanks killa again!) this plant has what appear to be genetics issues. it's gnarled and dusty looking. it's also throwing what look to be albino leaves. interesting to say the least. topped nicely.
-1x wrecked homicide clone (obviously killa!) this one looks like basil as it was throwing roundish, non-serrated leaves. it was partially a crazy pH meter as well as too many PPMs with the nutes. it has recenlty stated to grow regular, serrated leaves. it did however top nicely.
-1x g-13labs fem'd diesel (thanks vaped!). this is a squaty bush. it's almost round. the growth is super dense. this one loved being topped!
-1x dinafem fem'd white widow (thanks vaped!) this plant is also a squaty bush and almost round. the leaves on it aren't very big at all, including the fans. it's weird considering all the others have fans bigger than my hands. she's nice and dense. this one also loved being topped!
-1x reserva privada fem'd OG kush. this one started a little tall and lanky, but too well to topping. it has recenlty started to fill out nicely. took well to topping.
***these have been vegging for 20 days in 20oz platic cup hempys***
-3x greenhouse fem'd white widows (thanks irydyum!). these were started behind the rest of the pack. they are about 3" tall but are thick and bush with hardly any spacing between the nodes. their leaves are already bigger than the DWW. i haven't topped/FIM'd yet.
i topped most of them and tried FIM the DBP and maybe another, can't remember. it was my first try. i'll definitely be trying it in the future!
i have taken a 3x DBP, 3x OG kush and 2x WH, DWW & diesel cuttings. i put these in jiffy pellets with in a platic tub. i covered the tub with plastic wrap and placed it on a heating pad due to aforemention temps. it seems to be sitting at about 78F and 81% humidity.
i will be borrowing a aeroponics cloner to compare the differences. i shall report the findings.
that's about it for now. i'm sure i'll think of more later. thanks for tuning in!
-shake
pic 1- DBP
pic 2- DBP top
pic 3- diesel
pic 4- diesel top
pic 4- greenhouse WWs
welcome to headshake's hempy adventure!
pic 1- WH clone
pic 2- WH clone top
pic 3- basil looking leaves going back to serrted
pic 4- og kush
pic 5- og kush top
welcome to headshake's hempy adventure!
pic 1-4 WH (from seed) showing albinoism
pic 5- WH in soil to fill in the 5th slot
ok, gotta bounce. it feels good to be contributing at least somewhat!
one!
-shake
welcome to headshake's hempy adventure!
Nice cant wait to watch them grow. :thumbsup:
welcome to headshake's hempy adventure!
Those Round leaves seem interesting... Nice show
welcome to headshake's hempy adventure!
I'm in!
Some nice stuff, really interested in seeing that DBP grow out. :thumbsup:
I'm a big fan of anything purple comin' from Killa. :cool:
Is that WH albinism local to one branch? Did it exhibit this early in growth? That's pretty cool lookin'. :upsidedow :D
welcome to headshake's hempy adventure!
really nice grow hope they all come thru with a good amount !!
i have a question headshake
Ive been interested in the hempy buckets for maybe three days now but i have not read were someone explains how to water them i now only know how to make them but how do you water them thru the top ? or is the hoe at the bottom for watering in which you add water in the resovoir. then gets sucked in the container?
welcome to headshake's hempy adventure!
Quote:
Originally Posted by EvilCartman
Is that WH albinism local to one branch? Did it exhibit this early in growth? That's pretty cool lookin'. :upsidedow :D
it is not local to one branch. it is starting to show up more and more as the plant continues to bush out. it did exhibit it pretty early in growth. it's pretty wicked looking. i'm gonna try to get some clones with the albinoism in there and see what happens.
Quote:
Originally Posted by whenwethc
really nice grow hope they all come thru with a good amount !!
i have a question headshake
Ive been interested in the hempy buckets for maybe three days now but i have not read were someone explains how to water them i now only know how to make them but how do you water them thru the top ? or is the hoe at the bottom for watering in which you add water in the resovoir. then gets sucked in the container?
the hole in the bottom is to make sure that you don't over water them. when working with perlite it can float out the top if you have too much water. i suppose that you can water in that hole, but i water from the top... especially when the plants are young as the roots aren't very big.
the perlite and vermiculite have wicking and moisture retention qualities.
i hope i got all the questions for now. thanks everyone for tuning in!
as it turns out i think the DBP is a male, which kind of sucks, but i need another male for breeding purposes. so either way, it's a win. plus i've got a few more of those beans.
there should be some more stuff in the works in the near future. should get interesting!
-shake
welcome to headshake's hempy adventure!
Checking this out. Looking good, Chief. :hippy:
welcome to headshake's hempy adventure!
Wow Shake, those are some very nice plants ya got going on there:thumbsup:to say the least! A couple years ago i grew a plant out from a milk container and it got over 4', but it was outside, then turn male:wtf:
Keep er green:weedpoke:
:rasta: