Printable View
Heres how you do it step by step.
Heres how to make a lightbulb vaporizer i tried it a few days ago and it worked perfect, in typical vaporizer fashion there was no smell and the smoke was much cleaner. If you're interested, here's how to make one:
Take a burnt-out, regular sized lightbuild, and smash the cermic/metal end of it (shown in the red circle) with a spoon.(edit: Try a bulb that isn't burnt out if you want, but I hear they might implode or crack once you break the seal.)
Clean out all the wires, pieces, and bits of ceramic from the bulb. Next you MUST clean out the white frosting that coats the inside of the bulb. Shake some hot saltwater around inside the bulb. Try some water mixed with dishwasher detergent too. Rinse the bulb clean and let it dry (you don't want to be inhaling steam). It should be completely clear like this.
Next, get a bottle cap (almost any bottle cap will screw perfectly onto the bottom of the bulb). Punch two holes in it- widen one of the holes so you can fit a straw through.
The finished product should look like this:
To Use:Break up your herb and put it the bulb. Screw the cap on and hold the bulb underneath a flame (either a gas lighter or candle will work) until you see a green "vapor" swirling up. Drag slowly on the straw. Do not put the bulb right into the flame. The idea behind a vaporizer is that the weed is not being burnt or smoked, it is being heated until the THC vaporizes. Very smooth, give it a shot.
Makes a very good smoke. Thanks for the instructions! :thumbsup:
I DEMAND A VIDEO! i just want to see how it works when you heat it with bud in it.
awesome instructions CC... i think im gonna try this
as far as i know it dosnt make ash rather browned bud
video = GO TO WAYTOOMANY and look for it cause i'm too lazy to find it....and sad.....no bud and haven't had bud in like 3 days.........i'm broke
i'm definetly gonna make one of these thanks campbell.