that seems perfect
Printable View
that seems perfect
Damn man im gonna make something like that in like 5 minutes but I dont really like vapos(I just seem 2 enjoy the taste of the smoke), so im just gonna make a hole in the top and throw in a bowl and if all goes well i could have a bad ass bowl...hmm come to think of it i could make a bong 2 just extend the bowl downward. Anyway Ill post a pic when im done...maybe...im way 2 stoned right now
FUCK now i have 2 start again lol i found this clear like ball shaped light bulb i was gonna make me bong out of but i started drillin it out and the fuckin thing exploded! shit now i got glass everywhere but i could car less really. I kinda glad it broke thought cause i looked at the glass and it was sooooooo thin it would have broken prob while i was using it and that would not have been good...Attemp #2 here it goes
hey the rim just under the black part at the top of the bulb i cant cut it! are you guys using the aluminum light bulbs? cuz im using a surgical knife and i cant get through it
i cant get the damn thing off either lol can anyone help? did u cut throught that black thing or pry it off or what?
o shit i just got back first my guinea pig fuzzy died and then these chicks called me and wanted me to come over, so im continuing the bowl. To get the black part off i just drilled through it and it like broke so i just kinda stuck something in it(dont think that way u perv) and pryed it out
ok fuck it i give up this is just getting wierd. After shattering like 8 bulbs i was just gonna make a pipe where the bowl like comes out where the cap would be and then a tube would be connected to it making the bowl stand like upwards and then just have another tube come out for the mouthpiece and the bulb would just b a chamber. So anyway i drill it out and im washing out the bulb and all of the sudden the fucking metal part just falls off. The glass didnt break but the metal part just came off. so i just give up
^^ that sucks it kept breakin, hope they were already burnt out
anyways, i figgured out the black part, drilled it out with a knife, and did the whole bottle cap thing, heres the finnished pic
all you have to do is go look about 1 and a half threads down on the aluminum part of the bulb, take some scissors and just go to town, the filliment will break off as you do this and probably fall into the lightbulb, so take that out and wash it out so all the little glass particles are out of it, the cap and straw thing is self explanitory
as for smoking it, heres what works the best... hold the lighter so that the flame does not hit the glass, the tip of the flame should be about a centimeter or two below the glass (this way, all of the impurities in the butane burn off before the heat hits the glass, so you dont get that caked on black shit), you may need to preheat the bulb for a couple second, but as soon as you see vapors keep the lighter right there while your inhaling very slowly, you will see the grey vapors come right off the weed and continue into your mouth, if the vapors turn into smoke, then just back off the lighter a little bit, you wont feel anything until you start to exhale, then you die. the end.
the best way to cut the bulb is with a dremel tool. cuts it in about 5 seconds.