New and Improved: Featuring Sour Northern Lights x Nevilles Haze

Oh....and ps ....I use RO water.....so CalMag all the way......can't say for tap water.

Quote:

---

Originally Posted by Weedhound

Since It's a strain you haven't tried before I suggest looking at trichs but also doing some test runs along the grow to see where you like your weed to be when finished.
Snipping a bit of a bud will also make it ALOT easier to look at with your scope.

---

This is true but it pains me to clip a bud. Should I clip a towards the top of the canopy or the bottom (not the main cola but one of the tops of the other side shoots?? I can cut a bud off all the plants that appear to be close to ready and test them all.

What would you recommend. I didn't have too many trichs last grow (grew shwag seeds) so I could really press the bud against hte scope to see. bleh...

Looking forward to your recommendation otherwise I'll be clipping just 1 bud off my most 'ready' looking plant and trying to setup a quick dry to test.

Well the top usually finishes earlier and all you need is a bit. But to see how much longer you think you have left, take a bud from the lower section of the plant. It will DEFINITELY be behind the stuff closer to the light.

Quote:

---

Originally Posted by Weedhound

Well the top usually finishes earlier and all you need is a bit. But to see how much longer you think you have left, take a bud from the lower section of the plant. It will DEFINITELY be behind the stuff closer to the light.

---

Word.. I'll cut a bud about half way down the plant.

Agree with weedy...up near on of the tops, like a few nodes down...just a lil gram or two.... over at 215deg...prolly 30 min will do it...gives ya the same decarbolaxation as if the bud cured......bueno
good vibes

Quote:

---

Originally Posted by WhiskeyTango

Agree with weedy...up near on of the tops, like a few nodes down...just a lil gram or two.... over at 215deg...prolly 30 min will do it...gives ya the same decarbolaxation as if the bud cured......bueno
good vibes

---

I don't know if my oven goes to 215 degrees.. It only goes to 250 at it's lowest I think.

or put it on top of the tv or your pc or something and leave it overnight. It'll be ready tomorrow. ;)

Quote:

---

Originally Posted by Weedhound

or put it on top of the tv or your pc or something and leave it overnight. It'll be ready tomorrow. ;)

---

word.. going to find a bud right now :D

and I have a vaporizer.. no chlorphyll for me :D

Clipped 2 small buds off 2 of my plants and put them in the oven at 215 degrees. Going to wait about 25-30 minutes before pulling them out.

Also I now have 12 plants in my Hydro setup.

I have 2 more plants in the dome and they have a tiny root poking out but I probably won't put it into the system until tomorrow sometime.

I probably won't take my new cuttings for another week or so. I want to try to make some room in my 600 watt flower area before I start putting plants in there. If I wait a week that means the clones will be done in 2 weeks. In 3 weeks I hope to have at least 4 of the 8 plants chopped.

I'm excited. I'll let you know how the bud test goes.

Also it's worth noting that the first set of pots I got were kind of small. I bought more pots again recently and they were much bigger and seem much more suited for this setup. I anticipate the first 3 clones I picked will get root bound and may have to be cut down early.. Oh well.