COCAINE GROWING!!!!!!!!

i have made everything but LSD mescaline by far was the best cuz u can smoke the peyote as well

peyote is the shit!!!!! :D

endo...jay, what's the easiest drug to make? Like a piece of piss. Is there even one?

the best and easiest drig to make is codine. in the states opium is legal to grow, illegal to harvest. and from codine you can make heroin if you so chose.
heroin is alittle tricky you need to make codine then morphine then heroin.

ok here is the more common way to get codine...opium plants are the best but if u dont have em like me then ur outa luck.

You can extract Codeine, hydrocodone, Oxycodone etc. almost any Rx narcotic with water as because they are soluable in water.
Cold water extraction works well.

Below is an example of a codeine extraction.
The idea behind the following extraction is that
acetaminophen and aspirin (I'll use A/A from now on) are very
_insoluble_ in cold water. Codeine phosphate (the most common
salt of codeine) is very _soluble_ in water including cold water.
The following table explains:

Solubility (31C water) Solubility (21C water)

Aspirin 1g / 100 ml 1g / 300ml

Acetaminophen 1g / 70 ml 1g / 150 ml

Codeine 1g / 2.3 ml 1g / 0.7 ml
Phosphate

So as you can see, both A/A aren't very soluble in 21C
water, so if you cool the water to around 10C, the solubility will
drop even further. That way you can dissolve 20 tablets in 50ml
of hot water, cool the water down to 10C, filter the solution and
end up with the same amount of codeine as the tablets contained
but only a fraction of the original amount of A/A.

[...]

1. Obtain a quantity of tablets containing codeine, check to
see if they contain anything other than codeine, caffeine,
acetaminophen or aspirin. If they do, and you don't know whether
or not it will be a problem, your best bet is not to use them.
Measure out your desired amount of codeine (ex. 64 mg = 8 tablets
* 8mg/tablet). You may want to add 2 extra tablets as it is quite
likely you will lose some codeine in the procedure. As you get
more experience with the procedure you will be able to get
approx. 95% of the codeine extracted.

2. Measure out some nice hot water, use approx. 40ml / 20 tablets
or more if needed. I would suggest you don't go over 50ml for 20
tablets. I don't know if the use of boiling water would destroy
any of the codeine but your best bet is not to use it. Use hot
water but not boiling. Make sure the tablets dissolve completely.
Some dissolve on contact with water while others need some help
dissolving by crushing them. Note : not all of the tablet will
dissolve, there are water-insoluble fillers in the tablet and not
all of the A/A will dissolve either(which is what we want).

3. Place the solution in a cold bath, I just use some ice cubes
in a container of water. Stir the mixture occasionally until the
solution drops to about 15C or lower. You won't need a
thermometer to measure the temperature, just make sure it's
"cold". This will take about 30 min. If you wish to speed this
up, you can use less water to dissolve the tablets, and add ice
chips to cool the mixture faster. Just make sure you don't add
so much ice that you drastically increase the volume of the mixture.

4. Filter the solution using whatever you have. Coffee filters
work well, but lab filters work the best. Just make sure you
don't end up with obvious solids in the filtered solution. This
will take about 1 hr. You may also want to rinse the solids left
over in the filter with some ice-water to extract any remaining
codeine.



Side notes Pretty much anything that CAN be used IV is better if you shoot it. Snorting, on the other hand, in addition to being horrible for your sinuses, is wasteful, and just doesn't work as well. Why? Beats me. I'm only speaking from my own, and many others experience.

Don't use alot of water, use as little as possible. Codeine,hydrocodone, Oxycodone and morphine are all sensitive to heat and light. (Some more than others).
This method will work for oxycodone, but as a side note Percocet and most off-brands contain a relatively small amount of acetaminophen (about 350 mg or so) compared to the oxycodone (5 mg). Since oxycodone is very strong, 2 or 3 percs should have you feeling pretty darn good (as long as you don't have a huge tolerance). As a result, unless you are taking 10 or 15 percs per day, you needn't worry about acetaminophen ingestion.

then opnce you have that everything else is easier

Now, make up a caustic solution of about 200ml of water. This is done by slowly adding NaOH to the solution until it has a pH balance of 12 (use cheap pH strips). Then add 30ml of it to the codeine/water mix and then add 50ml of chloroform and shake and allow the heavier solvent to sink to the bottom. Then you must separate off the chloroform layer by using a siphon (use an eyedropper if you need to), then wash the remanding solution again with 30ml of chloroform and once again remove it. Now you must separate all the water from the solvent and I mean every last drop. All of the water must be out, and you can pipette it or use a separator of some kind (like a flask with a tap, so you shut it off when the water gets close to running through). Then evaporate off the chloroform with a pot filled with simmering water in it. Just have a plate sitting on top of the pot and slowly tip in solution and watch white crystalline codeine base appear as the chloroform reduces out by dryness.

Tips: You want white codeine not brown and always use glass; its easier to clean.

Next step producing Morphine from Codeine:
Now, you need to then measure out about 3 grams of pyridine HCL for approximately one and a half grams of codeine and melt it in a long boiling tube (or big test-tube). Then when melted, place in the codeine and it all must dissolve and be able to swish around. Then immediately plug the tube with a tightly rolled paper napkin. It will turn different colors and it will be hard to tell when it's cooked, but let it take about 5 minutes or when the temperature hits around 230 Celsius and then it will be done, and it will stick to the sides of the tube when ready. Then tip all of it into a clean beaker with 100ml of water. Then tip some water back into the now cooler test-tube and rinse all of it out into the beaker. Next add caustic solution drop by drop till you get to pH 14 (take about 3ml of the solution stated above). You will need some pH papers. Now wash the solution with chloroform say 40ml shake well and allow to settle or centrifuge (spin), pipette off the top aqueous layer. Then drop the pH to 9 and shine a light through it; you'll see it thicken with this brown mud like shit. Don't go past 9, add one or two small drops once you hit 9 and filter that crap out. The beat way is to use a vacuum filter with really good filter paper. Now, check the pH you want it to go no lower than 7.5 (using HCL spirits of salts and hydrochloric acid) while it gets to 8pH start rubbing the sides of the beaker with a glass rod or handle of a wooden spoon right in the liquid at the water level rub hard on the beaker glass and morphine will seed in clouds off crystals, then filter them out and dry high above an heating element on a metal spoon (leave the dope on the filter paper and dry it then it is easy to get off it flakes off in chunks).
Note: These crystalline codeine particles can be taken orally (under your tongue for faster results) or mixed in a drink, if you wish not to convert it into heroin.

Now, Converting your Morphine into street quality Heroin (diacetylmorphine)Procedure:
First, place some of your converted morphine into a metal spoon and add acetic anhydride and then cover with a piece of aluminum foil and bake in the oven at around 80 degrees Celsius, for at least 1 hour. Then uncover and turn the oven off. Allow the last of the acetic anhydride to sweat off the substance. Then place the remaining substance in the refrigerator. When the substance is cold, you can move it to a burner (torch lighter) and just heat till you think its at about at least 80 degree's and sniff a couple inches above it. It shouldnt sting your nose, if it does just heat it lightly some more until the smell goes away. Voila! Now the final product is street quality heroin. Ready to either be taken or sold.

oh and to the feds reading this my lab is better then yours :p

endo jay u sound cool man ;) u know your shit

hey is peruvian torch powder any good :p ?

Trichocereus peruvianus ( perivian torch cactus) mmmmm...it comes from the same family of cacti as san pedro...which has the same properties as peyote

yo endo J.. whats the easiest drug to make covertly, that doesnt really take that long to do.. something i can do in my apt?