im from britain, so i use tobacco in my joints, so i'll tell you how I roll:
first i get a piece of card (something like a train ticket will work fine), fold it once (longways... yeh... longways....) and then again, then unfold it so that you have a nice stand. the stand should have two slanted sides and then a nice slanted indent right down the middle where you can put your paper. then put your paper in that indent with the glue on the side furthest from you, then get some cardboard (part of your rizlas packet will do) and roll it up, and put it at the bottom to form the roach. then start putting your tobacco in the joint smoothing it evenly down the paper, then do the same with the weed. then pick up your paper, and gently roll it between your fingers until the weed and tobacco are spread evenly, then begin to roll your joint (try to get the very corner of the paper under the other side and roll the rest into it). usually this will produce a small cone that goes about 2/3 up the paper. from then on i simply mix weed and tobacco on a nice clean table, then start filtering it into the joint. when youve got it done, simply twist the end to close it up (possibly cut a little off if its too long) and then push it down.
then admire your artwork!