Help Me Fix My Pipe..

ok..ive gone thru this many times..
recently i dropped my sherlock bubbler and had a very clean break on the neck of it..
here is what u need. Go to any hardware store and buy EPOXY GEL. It is a lil thicker and doesnt run. Next, mix the 2 parts like the pkg says and put the glue n the parts of the glass that the smoke wont be touching, so try to get it towards the outside edge. You can always rub off the excess when u push the peices together. Then it hardens in about 10 min or so, and it should work perfectly. My bubbler hits perfectly, no glue is gonna get in the smoke, and you could never tell it was broken unless it is closely examined. Good luck, and some people jus dont understand the love one can have for a good peice of glass :)

i beleive he is correct ^^^

I think I'll do that GoBrad

if you do, do that... be really careful, maybe even go to the model car part of a walmart or something and get a detailing brush (really small thin brush) just to make sure you don't get it on the inside of the pipe, and since you are basicly going to be using next to no epoxxy.... here are some tips, first, only you shall smoke out of the pipe, because i'ts goign to require the utmost care when handling, don't chief on it (take a hit after hit and so on, so that the pipe gets warm) as that will more than likely weaken the seal... and never like bang the bowl in your hand to empty it, you're going to have to like get a paper clip or something so that all the crap left over just easily dumps out by turning it upside down

just blow out the ashes

not crazy glue :p