I'll have that posted for ya in about a week or two . I'm still guessing about 1/4 pound.Quote:
Originally Posted by nomadherbman
Maybe I'll start a guess the total weight thread ...
Printable View
I'll have that posted for ya in about a week or two . I'm still guessing about 1/4 pound.Quote:
Originally Posted by nomadherbman
Maybe I'll start a guess the total weight thread ...
Nice Donky's dongers For sure Mate..:D
Thats a really nice looking plant not much manicuring to do either..:D
the worst bit is the waiting..
Nice. When I move out, I'm growing for sure. How much did your setup cost you?
I built my growroom using 3/4" PVC and draped the frame with panda plastic (black on the outside, white on the inside. Am going to add a roll of mylar down lower to cover the bottom of the plants better. I used a half a sheet of 1/2" plywood for the floor -- I strategically placed extra PVC under the floor for extra support. The room is about 4x4x7 1/2. I grew 3 large plants in there with room for another. So far your into it for about $50.00 bucks, depending on if you can salvage some board for the floor.Quote:
Originally Posted by Oli
I used two 5' pieces of dog chain (about $5 for chains and hooks) and some 's' hooks to hang the lights from (that was the only expensive part--the lights that is)
I mounted (ingeniously I might add) a 100 CFM bathroom fan (you can get a fan for about $13 -- I spent more on a good one like $50.00) to continuosly vent the room -- the plastic wasn't secured at the bottom, plus the front flap seemed to provide adequate air intake.
Finally, I took a house fan we already had and stuck it in there -- blowing whever the light was on. I just upgraded to a standing fan, with random variable speeds ($40.00). I like the 2 and a half foot vertical flow it puts out.
If you go with cheap fans, you can do the room for under $100 easy. Use any extra plastic to make a liner for the floor. Tape it to each corner -- in case of spills.
Y'know I just had to respond to a thread entitled "DONKEY DICKS"....
Is it that the plants represent DONKEY DICKS???
Please elaborate....
You got it right, the long buds have the (I wish) girth and length of a donkey dick. The term refers to any long stalk of bud dense enough to cover a good length of stalk.
Not to be confused with pin-prick
So that vent is hooked right up to the rest of the house or did you just plug it in? nice setup btw.
Man...I wish I could get some of that...
The vent is just blowing into my room right now, but it's going to run up throught the closet ceiling and through a roof vent shortly
Wish I could smoke some with you ...Quote:
Originally Posted by Darkel