Printable View
A 10' bag!!! WTF! I would have to refill the bowl to fill that bitch. I just switched to regular oven bags. I couldn't bring myself to pay for another set of 'official' bags. I'll have to when that clear rubber insert that has an X cut into it becomes less flexable. Oven bags at grocery store are less than $3 for 6. Volcano bags are like $8 each when you buy them online and they don't sell singles. :(
I been using a volcano for about 5 yrs....the best way to use it IMO
Try using a 2 1/2 - 3 FT long bag
Fill the weed chamber 3/4 full (about a 1/2 g), preheat the volcano 340*-350*.....place the weed chamber on the volcano turn the compressor on let the hot air flow through the weed chamber until you can see the vape..... then attach the bag.
normally the first 10 sec or so is just air .... not vape.....doing it this way eliminates the extra air:D
I normally get 3 - 3 ft bags of vape:vap_smiley: per load
I would argue that the first 10 seconds are not all air. According to the instructions of the volcano, it says wait 3 seconds. When I use mine I usually will press the air button and then put the bag on right after(within 1.5 seconds). If the bowl is big enough I will see vapor filling the bag instantly.
An improvement that I think could be made to the volcano is:
- put lights on the red and green button on the digital volcano, so you can see them in the dark.
-the red button is stupid. they should make it a black switch. its confusing to other people that aren't familiar with the vape.(they tend to think that red means stop and green means go) and its not like you have any reason to hit that one button except for twice every sess (once to turn it on and once to turn it off) [contrast: i like the green button]
Try an experiment...fill your weed chamber about 3/4 full not 1/2 way or a 1/4full ...3/4 full:thumbsup: Place the screen assembly on top, now leave your bag offQuote:
Originally Posted by silentstrike
preheat the volcano to 340* .... turn the blower/compressor on.... set the chamber itself on your volcano....time until you can see the vapor 6-10 secs depending on your strain
If you set your temp to 360 or above you will get noticable vape (visually seen) in about 4-6 sec.
I vape at lower temps I makes the vapor smoother....the higher the temp of the vape extract the harsher the vapor in the bag
Because of the lower temperature I'm vaping at it takes the herb longer to heat up so the vaping starts a few seconds later:thumbsup:
Basically what I meant was.... wait until you can see the vapor then attach the bag weather it 3 sec. or 10 sec.